Explore Common FAQs About Wireless Nurse Call Systems

We are Manufacturer, Supplier, Exporter of Wired Nurse Call Systems, IP Based Software, Data Analysis Software, Wireless Bed Unit With Handset, OPD Call Systems from Pune, Maharashtra, India.

1. What type of Cabling is used?
It requires good Quality CAT 5 Cable.
2. How the Cabling is done?
Cabling is very simple to do. Please contact us to get cabling diagram.
3. How the connections are done?
Connections are very easy & with the basic Electrical knowledge one can do the connections.
4. Is the system reliable?
Yes the system is reliable & time tasted.
5. Does it require any periodic Maintenance?
As this is Electronic system & does not consist of any moving part virtually there is no maintenance of the system. The System is design to work 24 hrs & 365 days continually.

1. What is the Range of the System (What is the longest distance it can receive the Signal form)?
100 meters in open air. With obstacles & door closed it can work smoothly upto 60-70 meters.
2. What if the distance is more than 60-70 meters with obstacles?
We have signal repeaters (Boosters) which can be put in between main Control unit & the Call Unit. The signal repeaters increase the signal strength so the call unit which is at higher distance can work with control unit.
3. On one Wireless Control Unit maximum how many Call Units can work?
On a single system max 30 Call Units can work.
4. What if at a place more than two control units are there? Will both the controls units receive signal from Call Unit? i.e. Will cross connection take place?
No. Infact At a single/same place we can have 64 Control Units & still there will not be any cross connection.
5. What is the frequency it uses?
It uses 433 Mhz frequency range.
6. Does wireless system disturb other medical device functions?
No
7. How the setting is done in Wireless System?
Setting is very simple & you can start using the system immediately.

1. At Nurse Station
1. One 230 V 5 Amp regular Power Point is needed to supply the power to the system.
2. One rack/stand for control unit ( Size Of the Control Unit Box is 315 mm Length x 225 mm Width x 60 mm Height) One can hide the Control Unit Box if they wish & just hang the Display Unit On wall.
3. To hide the cable of Display Unit we advice to put plastic conduct pipe in the wall from Control Unit to the display unit.
2. At the Patient End or in The patient Room.
1. 2 Module Electrical Metal Box ( In case of Under Wall Wiring) or 2 Module Electrical Surface box ( In case of Open Wiring) for Door Indicator, Bed Unit & Toilet Unit one each.

1. At Nurse Station
1.One 230 V 5 Amp regular Power Point is needed to supply the power to the system.
2. At the Patient End or in The patient Room.
1. Two (2) Module Electrical Metal Box ( In case of Under Wall Wiring) or 2 Module Electrical Surface box ( In case of Open Wiring) for Bed Unit & Toilet Unit one each.